CTC Union FRM220 User Manual download pdf (Page 41)

3.2.9.1SystemReboot

When the converter is rebooted, all counters and registers are cleared and the converter starts fresh. If OAM is enabled, the discovery

process will start. After selecting the System Reboot menu item, a confirmation dialogue box will pop up. Click “OK” to reboot the converter or

click “Cancel” to leave without rebooting. The converter requires about 20~25 seconds to fully reboot.

3.2.9.2SaveandRestore

After performing configuration of the converter, the settings must be saved. Click the “Save To Flash” button to save settings. If you wish

to abandon all settings and return to the previous settings before doing configuration, click the “Load From Flash” button.

To restore all settings to factory default, click the “Reset To Factory” button. The IP address will also be reset, so you might lose

management contact with the converter. So, be careful.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46

No comments

CTC Union FRM220 User Manual Page 41